mounting rimfire motor
Hello, I'm building a Faltout for a fellow club member and need an answer for mounting the rimfire. The motor has a wheel collar on the back of it, that is too big to fit in the hold on the stock motor mount. I can take the collar off and there is a clip on the shaft to prevent it from sliding off. Is this sufficient, or do I need to drill out the hold in the mount? Please tell me what everyone else has done. Thank you
|
RE: mounting rimfire motor
I took the wheel collar off and after a few flights have experienced no problems.
|
All times are GMT -8. The time now is 09:05 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.