|
anyone tried this ?
Just to help protect your A-arms and make them a little tougher .[link]http://www.acehardware.com/product/index.jsp?productId=3573716&clickid=prod_cs[/link] |
RE: anyone tried this ?
i think i would just buy rpm arms and be done with it.
|
RE: anyone tried this ?
Yes i agree. But I already have 4 sets of stockers. I personally like the lst2 A-arms very solid, just looking to do something with them to make them tougher. I think it would work great plus you could add some color to them other than just blue or black.
|
RE: anyone tried this ?
probably look good on some chassis plates, I was thinking about using some spray on bed liner for the top plate on mine, but not sure might just go CF?
|
RE: anyone tried this ?
Funny. I might be trying that rubber coating stuff on my side rails. I just snapped the left rear side rail today bye the gas tank. I ran my truck up a tree to do a back flip off of it and it landed on the back rear tire and snap.
|
RE: anyone tried this ?
theres no structural strength to that... its a soft coating, if the arms gonna snap, its gonna snap. all that is is extra weight IMO.
|
RE: anyone tried this ?
Your right it is a soft coating. But it is the same material that RPM uses. Just like tool companies use on their handles. Again yes they will break just like RPMS break. But it will add a little protection, also so color. Anyway this is just something I stumbled across. I will post some pics when I do it to a couple of my A-arms. Prolly this weekend I will give it a shot. I will prolly do the front and rear dogbones also, just to give it some color. i don't care about the weight for I am just a club racer and basher.
|
RE: anyone tried this ?
I was under the impression RPM used a stronger material and a different structural design to increase strength. Ive never actually owned RPM arms though to feel them, I didnt know they were soft on the outside..
|
RE: anyone tried this ?
ORIGINAL: glk420247 Your right it is a soft coating. But it is the same material that RPM uses. Just like tool companies use on their handles. Again yes they will break just like RPMS break. But it will add a little protection, also so color. Anyway this is just something I stumbled across. I will post some pics when I do it to a couple of my A-arms. Prolly this weekend I will give it a shot. I will prolly do the front and rear dogbones also, just to give it some color. i don't care about the weight for I am just a club racer and basher. |
RE: anyone tried this ?
Simply one of the worst ideas I've read on the intraweb....[:@]
Steve |
| All times are GMT -8. The time now is 10:13 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.