TheShirt

My Feedback: (2)

Plane was a retirement gift. Anyone know what it is???

All Fiberglass Fuse 55"
Fully sheeted wings 60" span

What should the control throws be set at?

jeide

My Feedback: (111)

Hi. It looks like a Bob Smith Patricia.

TheShirt

My Feedback: (2)

Another view

roncoleman

My Feedback: (14)

Looks like a SBA/Speeda from FK

8178

My Feedback: (17)

It certainly is, and one beautiful and great flying aircraft too! A friend had one in the early 90s and I ordered one but the FK production of the kit was slow and I couldn’t get one. I still have the one page listing showing the FK kits. Bought my Tiporare instead.

In my opinion these were the last of the really beautiful looking pattern aircraft.

mike gruenwald

the fk airplane is a copy of the "blue angel" an mk kit

Deadstik

My Feedback: (8)

Ron wins on this one...!!!!!

The Patricia is only a bit different.. I'll post a pic tonight.


Dan


Carolina Custom Aircraft

roncoleman

My Feedback: (14)

8178, That was to easy. I remember the FK thread. Still would like to find a
couple of their kits. That Speeda looks sweet.

Ron

TheShirt

My Feedback: (2)

Thanks guys.
So where can I find some info on this Speedo?
Anyone know what the control hrows should be set at?

tipo750

I remember a few guys at one of the clubs I belonged to had a Speeda... I started trying to save up my pennies (I was a teenager) and finally scraped up the 150 bucks for the kit, only to find out that it went out of production!

roncoleman

My Feedback: (14)

TheShirt,

Why not use the throw setting from one of your other aircraft, for low-rate and add little more for your high-rate as a start. Maybe 8178 can help you out with a little info.

Ron

8178

My Feedback: (17)

Here is a FK SBA Speeda 60 build http://www.rcuniverse.com/forum/m_7510820/tm.htm

dhal22

I just noticed i now own this plane. isn't that unusual?

Free Bird

Not very unusual or surprising! Enjoy it, it's a beauty!

FB

dhal22

I enjoy it by looking at it. Maybe I will fly it next spring. I was cruising through some older threads and said "wait a minute, I've seen that plane before!". I need to find an air adaptor for the Rhom retracts air inlet valve though.

8178

My Feedback: (17)

What part are you looking for http://www.rcuniverse.com/forum/fb.asp?m=10223769

dhal22

How to input air into the Rhom inlet valve is the issue. apparently there is an adapter that i don't have.

8178

My Feedback: (17)

Are you missing the probe shown on my page? If so the old style Spring Air probe works with the Rhom valve. They might have some left. The probe just slides in the valve and seals because it has a tapered shape.

dhal22

Mike, I missed your advice there. I saw spring airs and didn't follow. I will revisit your thread. Thx

dhal22

It appears I need to check with spring air.