BVM 1/4 Yak 130, Upgraded Futaba BLS 157 SBUS servos & other mods
#1
Thread Starter
My Feedback: (34)
Join Date: Jun 2002
Location: Augustine, Fl
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
BVM 1/4 Yak 130, Upgraded Futaba BLS 157 SBUS servos & other mods
This is a nice BVM YAK 130 jet designed for 2 kingtech turbines. It can be purchased with RTF with turbines or without.
The jet has had various upgrades:
1, Instead of the plastic tanks, it now features 2 jet tech kevlar tanks, each with a 3.5 liter capacity
2, Many of the air cylinders were upgraded to ultra precision cylinders, and additional cylinders were added to ensure that all doors close properly
3, All of the servos were replaced with FUTABA BLS 157 Sbsus servos, while some people say the stock Spark Servos are OK, others said they had issues, so address they were changed to reputable futaba servos which are more than enough for this jet.
4, Upgraded light kit by Booma RC (runs on 12 volt / 3s lipo) very bright.
5, Dual Fromeco 5200 LION batteries.
6, upgraded dreamworks airline
7, Smoke system with smoke tank using POWERBOX smoke pump
8, Full landing lights with 3d printed custom housing for the nose and mains.
The jet is being sold without turbines, however, should you decide, 2 matched and sequential K-140 G1 turbines can be added for an additional $3500.00, These have very low runtime (under 5 hours) and are perfect for the jet.
To complete the jet, you will need to add a Power Safe RX.
Please note, there is no damage on the jet.
I can ship this jet without a problem.
The jet has had various upgrades:
1, Instead of the plastic tanks, it now features 2 jet tech kevlar tanks, each with a 3.5 liter capacity
2, Many of the air cylinders were upgraded to ultra precision cylinders, and additional cylinders were added to ensure that all doors close properly
3, All of the servos were replaced with FUTABA BLS 157 Sbsus servos, while some people say the stock Spark Servos are OK, others said they had issues, so address they were changed to reputable futaba servos which are more than enough for this jet.
4, Upgraded light kit by Booma RC (runs on 12 volt / 3s lipo) very bright.
5, Dual Fromeco 5200 LION batteries.
6, upgraded dreamworks airline
7, Smoke system with smoke tank using POWERBOX smoke pump
8, Full landing lights with 3d printed custom housing for the nose and mains.
The jet is being sold without turbines, however, should you decide, 2 matched and sequential K-140 G1 turbines can be added for an additional $3500.00, These have very low runtime (under 5 hours) and are perfect for the jet.
To complete the jet, you will need to add a Power Safe RX.
Please note, there is no damage on the jet.
I can ship this jet without a problem.