QQ Yak 54 102'' with DA 100 engine, smoke and JR 8711 , 8411 servos
04-04-2018, 08:34 PM
#1
Thread Starter
My Feedback: (30)
Join Date: Nov 2002
Location: flemington,
NJ
Posts: 493
Likes: 0
Received 0 Likes
on
0 Posts
QQ Yak 54 102'' with DA 100 engine, smoke and JR 8711 , 8411 servos + smaller YAK 54
This was purchased used a couple years back and don't have time to fly it. Engine and servos work great. It comes with the smoke system. I would be willing to part it out in the following configuration. I am only keeping the receiver.
GG YAK 54 plane servos motor and everything you see minus the receiver. 1200$
plane, motor, smoke system, spinner, servo horns and hardware 800$
plane, spinner, servo horns and hardware 400$
For my other smaller YAK
Extreme flight 68" YAK 54 with OS 120 surpass 3 pump engine
This is an extreme flight 68" yak 54 with an OS 120. This was my spare kit that I started building after an accident on my other one. The wings were good so I used my original set. That is why there is a new set of wings included. The OS 120 I bought used with a few gallons. I started it and it runs great .The airframe itself is never flown. I will sell it in the following configuration
Airframe with extra wings, hardware, tru-turn spinner HS 81 throttle servo 175$
With the addition of an OS 120 $350
GG YAK 54 plane servos motor and everything you see minus the receiver. 1200$
plane, motor, smoke system, spinner, servo horns and hardware 800$
plane, spinner, servo horns and hardware 400$
For my other smaller YAK
Extreme flight 68" YAK 54 with OS 120 surpass 3 pump engine
This is an extreme flight 68" yak 54 with an OS 120. This was my spare kit that I started building after an accident on my other one. The wings were good so I used my original set. That is why there is a new set of wings included. The OS 120 I bought used with a few gallons. I started it and it runs great .The airframe itself is never flown. I will sell it in the following configuration
Airframe with extra wings, hardware, tru-turn spinner HS 81 throttle servo 175$
With the addition of an OS 120 $350
Last edited by da_man; 04-04-2018 at 08:47 PM.
