Jetcat P160 0 hrs SMOH Kero start
#1
Thread Starter
Join Date: Jul 2012
Location: West Palm Beach,
FL
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Jetcat P160 0 hrs SMOH Kero start
Back from service mid-2018, this P-160/Titan-SE has only been out of the package for pictures since George at JetCat packed it up from a full service.
This is an older generation motor, officially a 'Titan' equivalent of a P-160SE prior to the naming scheme changes.
See the service ticket as an attached picture, this is a fresh 0 minutes since overhaul motor at this point and I instructed George to do whatever he could to make it as much like a new P160 as possible. New bearings, updated compressor wheel, latest ECU firmware, kero start, etc etc.
Included but not installed for risk to the threads, the kero start plug conversion will require you to thread this in and verify the ECU is set for kero start prior to initial startup.
Please note JetCat does not reset the clocks to "0" runtime so this motor is 0 hrs SMOH /14.5hrs TT. Next service will be due in 25 hours of runtime or approximately 39.5hrs TT
Included: motor, mounting brackets as shown, all solenoids, all cables and wiring, fuel pump, kero conversion kit, ecu.
Not included: no battery included, nothing propane start related is included, and no GSU is included as I do not have a GSU included in this sale and am not offering one for sale here.
Just invested over $1,000 (shaking my head) asking $1,695
I will ship worldwide at buyers expense and with whatever level of insurance you choose at the buyers expense.
This is an older generation motor, officially a 'Titan' equivalent of a P-160SE prior to the naming scheme changes.
See the service ticket as an attached picture, this is a fresh 0 minutes since overhaul motor at this point and I instructed George to do whatever he could to make it as much like a new P160 as possible. New bearings, updated compressor wheel, latest ECU firmware, kero start, etc etc.
Included but not installed for risk to the threads, the kero start plug conversion will require you to thread this in and verify the ECU is set for kero start prior to initial startup.
Please note JetCat does not reset the clocks to "0" runtime so this motor is 0 hrs SMOH /14.5hrs TT. Next service will be due in 25 hours of runtime or approximately 39.5hrs TT
Included: motor, mounting brackets as shown, all solenoids, all cables and wiring, fuel pump, kero conversion kit, ecu.
Not included: no battery included, nothing propane start related is included, and no GSU is included as I do not have a GSU included in this sale and am not offering one for sale here.
Just invested over $1,000 (shaking my head) asking $1,695
I will ship worldwide at buyers expense and with whatever level of insurance you choose at the buyers expense.