DeHavilland DHC-2 Beaver 20cc
Making room to finance another project. This DHC-2 Beaver is not an ARF but a laser cut kit by Moustache Model Works.
About the model: 91" wingspan, two piece wing, length 57.6", Scale 1/6.3 DLE 20ccRA with two military scale props from Falcon Props Simulated radial engine All Jr 2721 servos covered with Monokote and Callie Graphics Position, rotating and landing lights Simulated corrugated Ailerons, flaps, elevators & rudder Interior finish including pilot Operating entry doors Paint scheme of the U.S. Army VIP transport Manual and plans included this model is prepared to mount floats that can be purchase from Moustache Model Works All of the above are included minus the receiver and battery Asking Proce $850.00 No shipping, but could travel up to 100 miles to deliver Payment by cash or Money Order ( No PayPal) |
Hello I'd buy today if there was any way to get that to Detroit area
|
PaulMc, If you can make the necessary arrangement for packaging and shipment, this model can be yours,
Thank you, Rene |
ReneWhat is the span and height of the stabilizers. This should determine crate size.
thx Paul |
Paul,
The vertical stab is 14" without the tail wheel attached, with it attached 16" The horizontal stab is 31" Rene |
All times are GMT -8. The time now is 11:44 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.