Zero UAV YS-X4-P auto pilot system
01-05-2014, 08:31 PM
#1
Member
Thread Starter
My Feedback: (1)
Join Date: Oct 2004
Location: Dhahran, SAUDI ARABIA
Posts: 83
Likes: 0
Received 0 Likes
on
0 Posts
Zero UAV YS-X4-P auto pilot system
Greetings,
I just got a zero UAV YS-X4-P auto pilot system, and I need some help with its setup. I need to know how to connect my JR receiver to the system. This manual does not explain this. Also, I am not sure what does PTZ1, PTZ2, and PTZ3 connection mean. Please help.
Thank you.
I just got a zero UAV YS-X4-P auto pilot system, and I need some help with its setup. I need to know how to connect my JR receiver to the system. This manual does not explain this. Also, I am not sure what does PTZ1, PTZ2, and PTZ3 connection mean. Please help.
Thank you.
01-05-2014, 10:26 PM
#2
Member
Thread Starter
My Feedback: (1)
Join Date: Oct 2004
Location: Dhahran, SAUDI ARABIA
Posts: 83
Likes: 0
Received 0 Likes
on
0 Posts
I finally got hold of the manufacturer, and I was told that i must use a s-bus receiver with this system.
But I am still not sure what that is and if I could connect it with my JR PCM9 radio.
Any advice?
Thanks.
But I am still not sure what that is and if I could connect it with my JR PCM9 radio.
Any advice?
Thanks.
01-06-2014, 07:21 PM
#3
Senior Member
My Feedback: (17)
Join Date: Dec 2003
Location: va veach,
VA
Posts: 1,963
Likes: 0
Received 0 Likes
on
0 Posts
S-bus is a proprietary Futaba system that uses a digital bus instead of analogue signals to the servos. Won't work with JR.... from what you're saying.
