50cc Kantana 85" (blue)
I tried to install wing tube, it fits fuse. Will not go into wing tubes. The tube in the wings are cardboard and fit the alumn. wing tube very tightly. Is there a way I can lubricate the tubes to make them serviceable? I thought (was told by nitro) this was a new design however it seems to be an early design. I thought everone had done away with the cardboard tubes because of this problem. Please respond, Thank you.........Jim
|
RE: 50cc Kantana 85
I've resorted to putting a bit of sandpaper on a dowel to slightly enlarge wing tubes, when faced with the same thing.
|
RE: 50cc Kantana 85
opjose, Thanks for your response. I found a small bottlecap that is about 1" long and slightly smaller than the tube that I drilled a 3/8 hole thru stuck a 3/8 dowel thru the hole and filled the cap with epoxy, wrapped and glued sandpaper around it, cut the dowel to 18" and used it in my drill carefully....It's still tight but manageable....Thanks again. Jim
|
RE: 50cc Kantana 85
bipeflr,
how close are you to flying yours? is it this one? http://www.nitroplanes.com/giscka50arfn2.html would you recommend it? for the price it's hard to ignore. thanks, bart in NJ |
RE: 50cc Kantana 85
Barchiola, I wont fly until spring and it is not ready yet. The manual they send shows the other Katana except they list the flying weight as 17 lbs. and it feel it but I havent tried to weigh it. The joints seem to be glued lightly or not at all. I will use a DM 55 engine in mine but I had to cut the firewall back 2" and it was lucky I did as the firewall was keyed into the fuse sides but I pulled it apart without breaking anything(no glue holding it) So, be prepared to do more work than expected if you get it but if you are willing to do that then it can still be a bargin. On the firewall if I hadnt cut it back the carb linkage and needle valves would have been in the firewall and unassebale. If you have any other questions let me know. Jim
|
RE: 50cc Kantana 85
thanks for the reply jim. i may try to find a good used hangar nine cap instead.
enjoy your plane and happy holidays bart |
RE: 50cc Kantana 85
Okey dokey. Jim
|
All times are GMT -8. The time now is 01:15 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.