NitroPlanes HA-420 Jet specs needed
 

Hello,

I have recently purchased the Honda HA-420 jet, but am in need of some guidance, as the manual does not give any specs on the size of the Servo's required, and the size of the brushless outrunner motorors needed to fly this Jet with good power when needed.
Any info provided would be a great help, as i can not find any.

thank you,

RRRaptor

RE: NitroPlanes HA-420 Jet specs needed
 

they use standard servos. As for the power system you need to calculate the finish weight with the electronic equipment installed.

I'm sure the person in the video can give you more pointers. PM flyboytha1

John
Nitro Planes

RE: NitroPlanes HA-420 Jet specs needed
 

I've Got This One John,

Hello My Friend I'm Using (2) Axi 2820 Motors, (2) Eflite 60Amp Speed Controls, Hitec Standard Servo's Only One For My Elvator, No Issues With The One, (2) 4 Cell ThunderPower 2600 Lipo's, In All Flying Video's I'm Only Flying At Half Throttle There's Plenty Of Power In Those Motors. Here's My Last Flight Last Week In Arizona At The Arizona Fun Fly.

http://www.youtube.com/watch?v=iuCZcS0ukxU

RE: NitroPlanes HA-420 Jet specs needed
 

Flyboy,

Thank you so much, I have just bought 2- Electrifly SS -60amp ESC's, and was given 2-RIMFIRE 35-48-700kv's, and i will work on getting the servero's and reciever in the next week or so. Thank you so much for your help, very much appreciated. Any other tidbits you thin k i should know about on this project, feel free to school me :)


RRRaptor

RE: NitroPlanes HA-420 Jet specs needed
 

You Should Be Good To Go< Amymore Question Feel Free To Send An Email :)

RE: NitroPlanes HA-420 Jet specs needed
 

What size prop are you using for this setup? Also would a Hirunner 2814-8 engine work well with this setup? I purchased one and this is what was supplied with a reciever ready version, however I am not sure if this will be enough power for this plane. Just in case I ordered a 2820 size outrunner motor with 1400kv...

RE: NitroPlanes HA-420 Jet specs needed
 

Also, what are your flight times looking like, what type of watts and amps are you pulling with these motors and this battery setup?

RE: NitroPlanes HA-420 Jet specs needed
 

My Flight Times Are Set A 4:30 On The Timer, That Way At 5 Minutes She's Already Down.

Never Tested The Watts And Amps. Just Flew Baby, Just Flew. Lol!

RE: NitroPlanes HA-420 Jet specs needed
 

Prop Sixe Is 9X7 APC Pusher Props,

I've Never Used Those Motor Called Hirunner. Sorry :(.

[email protected]
 

I need any kind of information on the HONDA -420 PLEASE HELP.