RCU Forums - Bobcat 52 Fuselage Issue

RCU Forums (https://www.rcuniverse.com/forum/)

- NitroModels Support (https://www.rcuniverse.com/forum/nitromodels-support-456/)

- - Bobcat 52 Fuselage Issue (https://www.rcuniverse.com/forum/nitromodels-support-456/8954864-bobcat-52-fuselage-issue.html)

dneisler

07-22-2009 12:53 PM

Bobcat 52 Fuselage Issue

I have a bobcat 52 with a fuselage that has the former glued in right where the wing anti rotation rod goes. How can I got about getting a replacment?

opjose

07-22-2009 03:00 PM

RE: Bobcat 52 Fuselage Issue

You should be able to heat the former with a hot air gun ( don't use a hair dryer ) from the inside of the fuse.

This will loosen the glue, and then you can pop the former forward or sideways without damaging it.

Reglue it in place with a liberal application of epoxy to clear the rod.

I've done this on a couple of Bobcats without problems.

Some people have used this technique to remove ALL of the formers in preparation for mounting a TURBINE and electronics on the Bobcat... amazing.

All times are GMT -8. The time now is 04:24 AM.