on-your-six

where do you guys run your receiver antennae when you have a tuned pipe

Jaco

Do you have the rx in the hatch? I made a hole from the bottom of the fuse to the rx compartment.

on-your-six

that is what i did but with the tuned pipe
it is very close & runs along side the
antenna
kinda worried about interference

AFSalmon

My Feedback: (3)

the antenna should run along the left side of the fuselage.

on-your-six

ok thanks did you just go out the back of the
receiver box and run it along the fuse

martyg

My Feedback: (42)

Just bury a small nylon tube into the foam core before sheeting the fuselage.

on-your-six

i have the arf version kinda hard to install a tube now

AFSalmon

My Feedback: (3)

Yes, I just ran the ant. out the hatch area through a hole in the bottom of the fuse and then along either the bottom or left side of the fuse. You can still install a short piece of nylon tube from the bottom of the fuse straight up into the rx hatch area pretty easily. Just drill the hole in the bottom balsa fuse capping and sharpen the nylon tube end and hand feed it up. Works really slick.