RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Park Flyers & Backyard Flyers (https://www.rcuniverse.com/forum/park-flyers-backyard-flyers-148/)
-   -   Hobbyzone Sport Cub S binding (https://www.rcuniverse.com/forum/park-flyers-backyard-flyers-148/11676945-hobbyzone-sport-cub-s-binding.html)

lbarnes 04-01-2020 01:09 PM

Hobbyzone Sport Cub S binding
 
Well, I have not flown this plane in abut 1 yr.

Was going to take it out but it lost it's bind with my DX9.

I tried to bind it and the first attempt was no bind. Second attempt was a bind but the red LED is still flashing and no response from controls.

I thought maybe the throttle trim was too high so I set the trim as far down as possible. still no good bind.

Moved TX in the other room and tried to bind, still get flashing led on RX.

Tried binding with throttle in full position (thinking maybe setting got reversed). No luck.

Any suggestions?

guapoman2000 06-11-2020 06:05 AM

Yes, Throttle trim has nothing to do about success criteria of Binding any Transmitter to Receiver. It will still Bind and Throttle Trim has everything to do with being able to Arm the Throttle later when you have the model all active and the motor will not arm due to Throttle Trim not in Null (OFF).

You didn't specify which Receiver you are trying to use?

All my Receivers in the Spectrum Bandwith are Spektrum brand. They are pretty much straight forward as I do as follows:
1. Install the Bind U-Cable in the appropriate input at the Receiver.
2. Connect "a" battery to the ESC power input.
3. While following my specific Tansmitter (DX7, first Generation), I turn ON the Transmitter in Bind mode.

Hope this helps!


All times are GMT -8. The time now is 12:43 AM.


Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.