My new Q40 from HC molds
#1
Thread Starter
Join Date: May 2003
Location: Mexico city, MEXICO
Posts: 353
Likes: 0
Received 0 Likes
on
0 Posts
My new Q40 from HC molds
Hello everyone.
Just sharing my new racer.....
Its intended to be a Proud bird and adjusted to fitt Vendetta wings
I made from Hydrocal molds techinque.
Just flew it yesterday with very satisfactory results.
Regards
Oddy
Just sharing my new racer.....
Its intended to be a Proud bird and adjusted to fitt Vendetta wings
I made from Hydrocal molds techinque.
Just flew it yesterday with very satisfactory results.
Regards
Oddy
#3
Thread Starter
Join Date: May 2003
Location: Mexico city, MEXICO
Posts: 353
Likes: 0
Received 0 Likes
on
0 Posts
RE: My new Q40 from HC molds
Hi Bill, thank you very much.
Actually the tail feathers were not made by me, one friend pass me on a composite stab and rudder.
Regards.
Oddy
Actually the tail feathers were not made by me, one friend pass me on a composite stab and rudder.
Regards.
Oddy
#5
Thread Starter
Join Date: May 2003
Location: Mexico city, MEXICO
Posts: 353
Likes: 0
Received 0 Likes
on
0 Posts
RE: My new Q40 from HC molds
Hi Kevin, you are right,
These one didn´t have the cheek cowls as it was the first test fuselage to see if it flies OK.
They are considered for the following ones.
Oddy.
These one didn´t have the cheek cowls as it was the first test fuselage to see if it flies OK.
They are considered for the following ones.
Oddy.
#7
Thread Starter
Join Date: May 2003
Location: Mexico city, MEXICO
Posts: 353
Likes: 0
Received 0 Likes
on
0 Posts
RE: My new Q40 from HC molds
Hi Sahartman21, thank you very much.
For a Q40 type yes its my first fuselage, anyhow previously I have made some Q500 and other kind of planes fuselages with the same Hydrocal molds technique.
Oddy.
For a Q40 type yes its my first fuselage, anyhow previously I have made some Q500 and other kind of planes fuselages with the same Hydrocal molds technique.
Oddy.