Sullivan M060 & 7.4V Powered Receiver/Servos
12-05-2012, 09:14 AM
#1
Junior Member
Thread Starter
Join Date: Dec 2004
Location: Milan, ITALY
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Sullivan M060 & 7.4V Powered Receiver/Servos
Hello everybody!
I installed a Sullivan M060 On-Board Glow Plug Driver in my plane (and it seems to work!).
The driver is powered by a 7.4V battery (2s LiPo).
The driver is also connected to a 7.4V powered receiver and servos.
Has anyone tried (for many hours/flights) this set-up before?
My fear is that the 7.4V voltage FED BY THE RECEIVER to the M060 could affect the LONG TERM RELIABILITY of the driver.
Thanks a lot in advance for your advice and suggestions!
Bruno (Italy)
I installed a Sullivan M060 On-Board Glow Plug Driver in my plane (and it seems to work!).
The driver is powered by a 7.4V battery (2s LiPo).
The driver is also connected to a 7.4V powered receiver and servos.
Has anyone tried (for many hours/flights) this set-up before?
My fear is that the 7.4V voltage FED BY THE RECEIVER to the M060 could affect the LONG TERM RELIABILITY of the driver.
Thanks a lot in advance for your advice and suggestions!
Bruno (Italy)
