Hitec servos
#1
Senior Member
Thread Starter
Join Date: Oct 2011
Location: Elberton, GA
Posts: 217
Likes: 0
Received 0 Likes
on
0 Posts
Hitec servos
Building a SIG 4 Star ARF and was going to try Hitec servos this time. What is a good standard operational servo by them ? Just regular flying no standing on tails etc , couple loops and rolls maybe. So give a clue etc. Been running futaba's etc. Ok that is the question and thanks. gphil
#2
My Feedback: (6)
Since I don't have a Sig 4 Star, neither you say which engine you will have installed. I will give you the tools I use to estimate the servos needed for a particular airplane that I'm not familiar with, or the specs are not listed on the manual....
Start with The expected speed of the aircraft:
http://www.rcpro.org/rccalc/pitchspeed.aspx
Then move to the required torque of the servos at the expected speed:
http://www.mnbigbirds.com/Servo%20To...0Caculator.htm
Hope that steers you in the right direction.
Rafael
Start with The expected speed of the aircraft:
http://www.rcpro.org/rccalc/pitchspeed.aspx
Then move to the required torque of the servos at the expected speed:
http://www.mnbigbirds.com/Servo%20To...0Caculator.htm
Hope that steers you in the right direction.
Rafael
#3
My Feedback: (158)
Building a SIG 4 Star ARF and was going to try Hitec servos this time. What is a good standard operational servo by them ? Just regular flying no standing on tails etc , couple loops and rolls maybe. So give a clue etc. Been running futaba's etc. Ok that is the question and thanks. gphil
#4
Senior Member
I like these
I've been using these for years in 40 size sport planes and recommend without hesitation. Good value for the products and support.
Standard analog:
HS-425BB Deluxe Ball Bearing Standard Servo
Part No:
31425S
High speed analog metal gear:
HS-625MG High Speed, Metal Gear Premium Sport Servo
Part No: 32625S
Here's a link to the Hitec servo's: http://hitecrcd.com/products/servos
Good luck!
-PD
Standard analog:
HS-425BB Deluxe Ball Bearing Standard Servo
Part No:
31425S
High speed analog metal gear:
HS-625MG High Speed, Metal Gear Premium Sport Servo
Part No: 32625S
Here's a link to the Hitec servo's: http://hitecrcd.com/products/servos
Good luck!
-PD
#5
My Feedback: (-1)
All a 4* requires are standard servos, the 425BB is a pretty good servo for the plane. These can also be used in the 60 size 4*. In any standard servo getting them with ball bearings is a good idea, nothing wrong with the bushed servos but the BB is smoother {you wouldn't notice the differences } but they will last longer.