Go Back  RCU Forums > RC Airplanes > Questions and Answers
Reload this Page >

Super Cub conversion a brushed motor

Notices
Questions and Answers If you have general RC questions or answers discuss it here.

Super Cub conversion a brushed motor

Old 10-13-2017, 09:33 PM
  #1  
Pyrokiwi
Junior Member
Thread Starter
 
Join Date: Oct 2017
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Default Super Cub conversion a brushed motor

I am keen to convert my sons Hobbyzone Super Cub which has a standard brushed motor to use a Orx R615X Receiver and a new speed controller.

The motor in Hobbyzone Super Cub only has two wires (red +v) and (black-v). What I need help with is:

1 - which wire do I need to connect the (red +v) and and (black-v) if I use a Plush -18A whihc has three red wires (A), (B) and (C). which wires do I use?
2 - Shoud I be using a new two wire speed controlelr and if so what should I be using?
3 - Can I use the standard servo with a Orx R615X Receiver

Many thanks in advance, Simon NZ
Old 10-14-2017, 06:44 AM
  #2  
jester_s1
Moderator
 
Join Date: Dec 2006
Location: Fort Worth, TX
Posts: 7,032
Likes: 0
Received 8 Likes on 8 Posts
Default

Brushed motors only use 2 wires. Brushless always needs 3 wires. So you'll eliminate the two wires and replace them with 3.

The standard servo should work fine with the new receiver.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.