Go Back  RCU Forums > RC Airplanes > Questions and Answers
Reload this Page >

AEROScout S 1.1

Notices
Questions and Answers If you have general RC questions or answers discuss it here.

AEROScout S 1.1

Old 08-21-2020, 10:52 AM
  #1  
barjd10
Junior Member
Thread Starter
 
Join Date: Aug 2020
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Default AEROScout S 1.1

Purchased a new aero scout s 1.1 fuselage after a crash, and had to remove motor, receiver, and other wiring from the crashed one. Forgot to take a photo of the proper configuration before taking apart. Any chance someone could post a picture of the configuration (which wires go where on the receiver? A txt or word doc describing the connections would work also.
Old 08-21-2020, 08:28 PM
  #2  
jester_s1
Moderator
 
Join Date: Dec 2006
Location: Fort Worth, TX
Posts: 7,062
Likes: 0
Received 15 Likes on 12 Posts
Default

It's not hard to figure out.
Take one servo and plug it in wherever you want. Move the sticks until it moves, then write down which surface that channel is supposed to be. It'll only take a few minutes to get it all right.
On the motor, if it's brushless, it'll have 3 wires going into it. If you get it all together and the motor turns the wrong way, switch any two wires.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.