Where to buy Nylon Wing Bolts?
#1
Thread Starter
Join Date: Jun 2002
Location: Atlanta, IN
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
Where to buy Nylon Wing Bolts?
Where can you get nylon bolts over 2 in? I'm looking for some wing bolts for a CAP 232 that are 3 1/2 in (1/4 x 20). Does Lowes have them?
#5
Senior Member
Join Date: Dec 2001
Location: Cranberry Twp, PA,
Posts: 235
Likes: 0
Received 0 Likes
on
0 Posts
RE: Where to buy Nylon Wing Bolts?
#7
Senior Member
My Feedback: (2)
Join Date: Jul 2003
Location: Louisville, KY
Posts: 254
Likes: 0
Received 0 Likes
on
0 Posts
RE: Where to buy Nylon Wing Bolts?
Look in the plumbing section of any hardware store or home center.
The are the same bolts that hold toilet seats on.
Cheap and readily available! Fix the toilet seat too!
The are the same bolts that hold toilet seats on.
Cheap and readily available! Fix the toilet seat too!
#8
Senior Member
Join Date: May 2002
Location: Phoenix,
AZ
Posts: 1,045
Likes: 0
Received 0 Likes
on
0 Posts
RE: Where to buy Nylon Wing Bolts?
I'd give you a handful if you lived here......I don't use them. I use #8 sheet metal screws, with the 1/4" hex head. Drill a 1/8" hole and they cut their own sharp threads. Install with a nut driver which doesn't slip and mess up your wing. Do they break off easily in a crash? No, but if you hit the wing hard enough to break off the nylon bolts, you usually tear things up pretty badly anyway.
I think I got started on this after I built a Joe Bridi Dirty Birdy over 20 years ago, and Joe had the wing held down with 6-32 bolts and blind nuts, if I remember correctly. I tweaked the idea from there to the SM screws. Now my friends do the same thing. Works for us!
Clair
I think I got started on this after I built a Joe Bridi Dirty Birdy over 20 years ago, and Joe had the wing held down with 6-32 bolts and blind nuts, if I remember correctly. I tweaked the idea from there to the SM screws. Now my friends do the same thing. Works for us!
Clair