CRRC Gas engine
#1
Senior Member
Thread Starter
Join Date: Sep 2004
Location: Green Point NSW, AUSTRALIA
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
CRRC Gas engine
I am after some feedback about this gas engine. I am after a gas engine in the range of 40 to 50cc for the World Models Extra 300S 74".
Havn't had a gas engine before and was looking at an alternative to a large four stroke glow. The one pictured below is a CRRC GF-45i. The pricing available here puts them under the price of Zenoah, ZDZ, DA and 3W of around the cc's I am looking at.
Ta.
Mark
Havn't had a gas engine before and was looking at an alternative to a large four stroke glow. The one pictured below is a CRRC GF-45i. The pricing available here puts them under the price of Zenoah, ZDZ, DA and 3W of around the cc's I am looking at.
Ta.
Mark
#2
Senior Member
Thread Starter
Join Date: Sep 2004
Location: Green Point NSW, AUSTRALIA
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
RE: CRRC Gas engine
Should have checked first.....below post answers my own question[sm=tongue_smile.gif]
http://www.rcuniverse.com/forum/m_31...tm.htm#3186031
http://www.rcuniverse.com/forum/m_31...tm.htm#3186031
#5
Junior Member
Join Date: May 2004
Location: bairnsdale, AUSTRALIA
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
RE: CRRC Gas engine
Hi
This engine was very inconsistent to start sometimes easy then other times it was a real pain, when it was going I could not get it to run properly at all, could never get a reliable idle or throttle response and it would not hold a steady top rpm it would be surging as if it was to lean and when richened of it would fuel up and run terrible. The inlet manafold was plastic and warped witch I had to fix, the muffler was made from re-cycled beer can and cracked and broke before I even got the engine into the air. I am a small engine mechanic buy trade and I played around with this engine for ages and trying everything I could think of I could not get it to run propley. I threw it under my bench and brougt a DA50, it was worth every penny!
This engine was very inconsistent to start sometimes easy then other times it was a real pain, when it was going I could not get it to run properly at all, could never get a reliable idle or throttle response and it would not hold a steady top rpm it would be surging as if it was to lean and when richened of it would fuel up and run terrible. The inlet manafold was plastic and warped witch I had to fix, the muffler was made from re-cycled beer can and cracked and broke before I even got the engine into the air. I am a small engine mechanic buy trade and I played around with this engine for ages and trying everything I could think of I could not get it to run propley. I threw it under my bench and brougt a DA50, it was worth every penny!