Go Back  RCU Forums > RC Airplanes > Questions and Answers
Reload this Page >

Aluminum spinner mod??

Notices
Questions and Answers If you have general RC questions or answers discuss it here.

Aluminum spinner mod??

Old 01-26-2007, 07:40 PM
  #1  
propjets4me
Member
Thread Starter
 
propjets4me's Avatar
 
Join Date: May 2006
Location: Parramatta, AUSTRALIA
Posts: 59
Likes: 0
Received 0 Likes on 0 Posts
Default Aluminum spinner mod??

Hi I have a 1.75 " spinner but the the slots for the propeller a bit small, any ideas on a good method of enlarging them slightly

I dont know if I should grind them with a dremel..if so will this discolour the metal with the heat

Or is there another method .. I would like to keep them as even as possible to help balancing when done


thanks
Frank
Old 01-26-2007, 07:56 PM
  #2  
alan0899
 
Join Date: Apr 2006
Location: Warialda NSW, AUSTRALIA
Posts: 2,275
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Aluminum spinner mod??

G'day Mate,
Half round, flat & rat tail files, will do the job.
Old 01-26-2007, 09:21 PM
  #3  
propjets4me
Member
Thread Starter
 
propjets4me's Avatar
 
Join Date: May 2006
Location: Parramatta, AUSTRALIA
Posts: 59
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Aluminum spinner mod??

cheers mate, it's off to bunnings I go!

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.