Propper prop drilling.........
#1
Thread Starter
My Feedback: (40)
Join Date: Dec 2001
Location: Waynetown,
IN
Posts: 2,476
Likes: 0
Received 0 Likes
on
0 Posts
Propper prop drilling.........
I was just curious how you guys make sure you are drilling the prop in the EXACT center. Short of putting it on a mill and indicating it, I have no better way.
I have been doing the typical drill press procedure, but it is not the ideal route. I do have access to a mill and I am going to start doing it this way I think, but if you have a good way to do it at home, I am listening.
Jeff
I have been doing the typical drill press procedure, but it is not the ideal route. I do have access to a mill and I am going to start doing it this way I think, but if you have a good way to do it at home, I am listening.
Jeff