RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Questions and Answers (https://www.rcuniverse.com/forum/questions-answers-154/)
-   -   Need help setup FPV system in Dynam Beaver seaplane (https://www.rcuniverse.com/forum/questions-answers-154/11626620-need-help-setup-fpv-system-dynam-beaver-seaplane.html)

ashishngupta 02-11-2016 12:29 PM

Need help setup FPV system in Dynam Beaver seaplane
 
4 Attachment(s)
Hey people im in the process of putting in an FPV system in My dynam Beaver. i had a few questions and need advice. but before that lemme give you and idea of what i have.

Just got the Fatshark Dominator V3 FPV Goggles
Fatshark Dominator 5.8GHz Receiver RX Module, Race Bands
Immersion RC 600mw 5.8 GHz A/V Transmitter
Fat Shark 3-Axis RC Trinity Head Tracking Module with Cables
FatShark 700TVL WDR CMOS FPV Camera with Pan/Tilt/Roll

other specifications
Spektrum Dx7 tx with Ar7000 rx
4s 3300 mah battery

trying to wrap my head around the best option...keep getting irritated with the wiring through the wing. im contemplating if i should keep the 5.8ghz tansmitter in the body or on top of the wing?.... i read these 600mw heat up so...... i dont know what to do? on the other hand i also read that since planes are up in the sky if the cloverleaf antenna in downwards it is better. should i keep the video 5.8ghz transmitter attached to the belly of the plane? i have attached some photos kindly have a look.

the wiring are a mess! I was also thinking getting a 25pin connector of some sort and attaching it to the wing wires...any advice?


All times are GMT -8. The time now is 10:00 PM.


Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.