RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Questions and Answers (https://www.rcuniverse.com/forum/questions-answers-154/)
-   -   What fuel should I use? (https://www.rcuniverse.com/forum/questions-answers-154/1884051-what-fuel-should-i-use.html)

Flyboy1958 06-08-2004 11:50 AM

What fuel should I use?
 
I have a Saito 72 and am a little confused about which fuel to use. I use Byron 15% with a 20% synth/castor blend for my OS46FX right now. Is this also a good fuel to use for my Saito?

Geistware 06-08-2004 11:52 AM

RE: What fuel should I use?
 
While this fuel will work and work well, I prefer a full synthetic oil/fuel combination.


ORIGINAL: Flyboy1958

I have a Saito 72 and am a little confused about which fuel to use. I use Byron 15% with a 20% synth/castor blend for my OS46FX right now. Is this also a good fuel to use for my Saito?

Steve Collins 06-08-2004 12:37 PM

RE: What fuel should I use?
 
I also prefer a full synthetic oil fuel.

Cool Power works well.

I also like Cool Power 30% Heli-mix and I am currently using Wildcat (all-synthetic) 30% Heli-mix. The Heli-mix just has a higher oil content.

Stick Jammer 06-08-2004 01:39 PM

RE: What fuel should I use?
 
Another vote for full synthetic. While some may like a castor blend, I feel it tends to gum up the valves and pushrods in a 4-stroke. I also like Cool Power, 15% works very well in my 4-strokes. The biggest key is to run them on the rich side, a lean running 4-stroke won't stay happy for long.

Ed_Moorman 06-08-2004 03:13 PM

RE: What fuel should I use?
 
If you haven't run it yet, break it in according to the Saito instructions. I have the .72 and a couple of .91s and all 3 run great. I ran 2 gallons of Omega 10% castor blend through each, a half gallon on the bench by their instructions and the rest in the air. Then I switched to 20% Cool Power heli blend. The Saitos seem to like more nitro and take a longer time to break in than OS or Magnum 4-strokes.

If you start off with synthetic, the ring has a harder time seating. You want the initial wear so the ring will seat-fit smoothly with the cylinder. After it seats well, the compression seal will increase.

Carlos Murphy 06-08-2004 11:59 PM

RE: What fuel should I use?
 
I use Power Master YS 20/20 in all of my Saito's and most of my 2 strokes.


All times are GMT -8. The time now is 01:56 AM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.