RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Questions and Answers (https://www.rcuniverse.com/forum/questions-answers-154/)
-   -   Uneven servos (https://www.rcuniverse.com/forum/questions-answers-154/5574330-uneven-servos.html)

torotim 03-17-2007 09:21 AM

Uneven servos
 
I just completed a CG ultimate using dual elevator servos (JR DS821) with a Y harness. One servo seams more lively than the other. When I move the stick on my 9303, one servo travels farther and quicker the other, but not all the time. This is just a strait Y harness, not a reversing or amplified one. what could cause this???

exeter_acres 03-17-2007 09:39 AM

RE: Uneven servos
 
could be a few things... but it is probably just the difference in servos....

ditch the "Y" (they are evil and bad) and use a seperate channel for each servo, then you can set end points seperatly...
and I think you can even adjust the speeds on the 9303 (not sure on that one as I fly Footooboo)

Tired Old Man 03-17-2007 10:29 PM

RE: Uneven servos
 
Yes you can adjust the servo speeds with the 9303. You can slow them down, but you cannot program them go faster than the designed transit speed. You can only do that if they are on separate channels. I agree on the Wye to join servos. They are evil and nasty things.

torotim 04-23-2007 10:00 PM

RE: Uneven servos
 
Ran them into the receiver individually and trashed the Y (which was a reversing Y after all, I forget in my old age) and everything is working just dandy now. Thanks!!!


All times are GMT -8. The time now is 06:06 PM.


Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.