RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Questions and Answers (https://www.rcuniverse.com/forum/questions-answers-154/)
-   -   Servos torque (https://www.rcuniverse.com/forum/questions-answers-154/5617965-servos-torque.html)

Flying freak 03-26-2007 08:17 AM

Servos torque
 
i was looking at ebay and found these- http://cgi.ebay.com/2-pcs-Tower-Pro-...QQcmdZViewItem


Specification :

*
Dimensions ( mm ) : 40.6 (L) x 19.8 (W) x 37.8 (H)
*
Weight 56g
*
Operation Voltage 3.5V - 8.4V
*
Connector Wire Length 200mm
*
Operating Speed (4.8V no load): 0.17sec/60 degrees
*
Operating Speed (6.0V no load): 0.13sec/60 degrees
*
Stall Torque (4.8V): 13Kg/cm
*
Stall Torque (6.0V): 15Kg/cm
*
Temperature Range: -30 to +60 Degree C
google calculator says

1 (kg / cm) = 89.5958634 oz / inch
does this mean that these servos are 1 343.93795 once servos[X(]

please do help me i obvously need it

BankYank 03-26-2007 11:24 AM

RE: Servos torque
 
Here ya go.
Stall Torque (4.8V): (13kg/cm) (180oz/in.)
Stall Torque (6.0V): (15kg/cm) (208oz/in.)

I have read that these servos are not the best for returning to the same center, BUT i can't say for sure.
Pat

Flying freak 03-26-2007 03:18 PM

RE: Servos torque
 
i dont know for the price i figure i can give them a try... throw them in a trainer (just to see how the responce is) not but too much $$ on the line...


All times are GMT -8. The time now is 09:40 PM.


Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.