![]() |
Backup RX battery question....
I wanna run a backup rx battery in case my rx battery fails. I got a couple questions though. I'll have to use 2 different batteries,but all are nimh's. 1) Can I use one 6v battery and one 4.8v battery(yeah I doubt it). 2) Can I use 2 different nimh 6v batteries,but with different mah's?
Thanks..... |
RE: Backup RX battery question....
ORIGINAL: Jester241 I wanna run a backup rx battery in case my rx battery fails. I got a couple questions though. I'll have to use 2 different batteries,but all are nimh's. 1) Can I use one 6v battery and one 4.8v battery(yeah I doubt it). 2) Can I use 2 different nimh 6v batteries,but with different mah's? Thanks..... Different capacities: Yes. I've done this on a couple planes and found each battery was drained proportionally. For example, each battery would be drained by say 40% of it's capacity at the end of the day. (not exact numbers, just an example) I'd also use a separate switch for each battery to add redundancy there too. |
RE: Backup RX battery question....
Chuck Hit the Nail on the Head. Bob |
RE: Backup RX battery question....
Dang Chuck, I was always told to run the same size battery and always wondered about that draw question, thanks. Always the two switches!! I have had several switches go out but only one battery.
|
RE: Backup RX battery question....
Hi Jester,
http://www.precisionaerobatics.com/p...ls.php?pid=272 This device is solid state with no moving parts to wear, vibrate and fail, it turns on and off with a magnet, takes all types of batteries and monitors battery condition as well as drawing equally from each battery. I use these in my more "precious" models. No I don't work for the company. Cheers, Colin |
RE: Backup RX battery question....
ORIGINAL: Crash Campbell Hi Jester, http://www.precisionaerobatics.com/p...ls.php?pid=272 This device is solid state with no moving parts to wear, vibrate and fail, it turns on and off with a magnet, takes all types of batteries and monitors battery condition as well as drawing equally from each battery. I use these in my more ''precious'' models. No I don't work for the company. Cheers, Colin Hi Crash, What device? At least on their US website, they don't seem to have anything like you describe. What is the name of the device? What category is it under? Sorry if it was obvious, but it's not idiot-proof obvious.......... Thanks |
RE: Backup RX battery question....
Gray Beard,
Remember, voltage is the pressure that delivers the mAh, the amount of energy stored. Think of two buckets of water (mAh) with pumps (volts) on each one. The voltage or pressure needs to be the same or all kinds of problems happen. The higher voltage will be trying to push its current into the lower voltage battery. However, the receiver will take the amount of energy it needs to run. Therefore, the difference in the capacity doesn't matter. It doesn't care who gives it to him, if it is available he'll take it. If one runs out he'll take it from the other. If the second one runs out.... we all know what happens then. Hope this helps, KW_Counter |
RE: Backup RX battery question....
ORIGINAL: Gray Beard Dang Chuck, I was always told to run the same size battery and always wondered about that draw question, thanks. |
RE: Backup RX battery question....
Hi,
It is on the Australian web site under large model accessories, click on the Australian flag. It is a german Emcotec switch that allows you to use two batteries of any type. I have been using two for over three years since I nearly lost a model when a mechanical switch self destructed. Cheers, Colin |
RE: Backup RX battery question....
I dont like adding complication to simple electronics myself I like the KISS method Keep It Simple Stupid.;)
although 5V relay circuit might work for whatever pack mah or voltage would have to sit down draw it out and find the relay (digikey is a good source), switching between batteries using a normally open contact on one pack and normally closed on the other. One pack would power the circuit closing the relay and sending its power to the switch and all the radio components when this battery failed or dropped too low the relay would open up and switch to the other pack. |
RE: Backup RX battery question....
ORIGINAL: ChuckW ORIGINAL: Gray Beard Dang Chuck, I was always told to run the same size battery and always wondered about that draw question, thanks. Crash, way cool device/switch. A bit out of my price range at the moment but I have a couple of planes I would like to have it on!! They just keep coming up with better and better equipment every time I look. Sure beats the days of going into radio shack to buy my electronics!! |
RE: Backup RX battery question....
Hi Gray Beard,
Yeah they arn't cheap but neither are some of my models:D. Don't forget that if you looked at the Australian site one Oz dollar is currently about 84 cents US, so the prices arn't quite so scary for those in the USA. Cheers, Colin |
| All times are GMT -8. The time now is 11:23 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.