Houston I have a problem Air retracts
Ok Now I am having a small problem I have the retract system installed and ready to use.
But now I cant seem to get enough pressure in the tank. I am using a small compressor it is set to max at 100psi. My air retract system uses a one way valve for filling the tank and I cant seem to get enough pressure in it if I put the gear down while filling the tank it works and also for fear up. What am I doing wrong I installed the system as instructed no leaks any where and no blocks . help!!!!!!!!!! Thank you. |
RE: Houston I have a problem Air retracts
If it works with the pump connected it sounds like the tank is not filling.
Are you sure that you have connected the one way valve correctly? Terry |
RE: Houston I have a problem Air retracts
The tank does get some pressure but not enough to move the retracts but just enough to unlock them and that is after holding to pump pressure to it for about five minutes .
|
RE: Houston I have a problem Air retracts
I have found the problem. I am using plastic three way splits for the air system and have found that the line going to the tank is is blocked must have come that way from the factory because I found another one the same way and had to drill it out to get it to work properly any way thanks guys for your input
hyflyer9. |
RE: Houston I have a problem Air retracts
Wow, now that could have been a real stumper! Glad you were able to troubleshoot it. New definitely doesn't necessarily mean good.
|
RE: Houston I have a problem Air retracts
I agree fully with that statement
hyflyer9 |
All times are GMT -8. The time now is 01:34 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.