Broken RX Antenna
I just stepped on the antenna of a micro Hitec reciever. It broke at about the halfway point and I have never had this problem before.
Can it be re-soldered, or am I just asking for a crash? Thank you, Graeme |
RE: Broken RX Antenna
re soldering is fine.
|
RE: Broken RX Antenna
As long as the length hasn't changed drastically there is no problem soldering it back together. Put a small piece of heat shrink over the solder joint to protect it.
Ken |
RE: Broken RX Antenna
Thanks guys - you just saved me $25 for a new receiver!Thank you,Grame
|
RE: Broken RX Antenna
I'm not sure on Hitec but I've bought replacement antennas for Futaba receivers before. Just pop open the receiver, remove the old, broken one then solder the new one in place.
|
All times are GMT -8. The time now is 01:33 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.