BUSA Sopwith Pup and G38
I am building the 1/4 scale Balsa USA Sopwith Pup, I was planning on using a Zenoah G38. Here is my problem, with the rear exhaust the engine is to long by about a 1 1/2 inches. Has anyone used a G38 with this plane and if so how did you mount it? pictures would be great. Normally I would cut some of the firewall away at the bottom to make room, but the landing gear block is in the way.
Any ideas would be great. |
RE: BUSA Sopwith Pup and G38
are you useing the bell mount if so remove it and drill a hole for the shaft , g-38 way over kill on this plane I'm useing a old g-23 it is just right
|
RE: BUSA Sopwith Pup and G38
Hi lazyace, I'm not using the bell mount,I was going to drill a hole for the shaft and mount it to the firewall. The muffler will be the problem, it's a rear exhaust.
|
RE: BUSA Sopwith Pup and G38
Most use a G-26....that's what I used on my BUSA DR.1 and it is perfect!!
|
All times are GMT -8. The time now is 10:16 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.