Having trouble tuning
 

I'm having problems getting my engine to start, and I need to prime it alot. Once I finally get it tuned, it stalls when I give it gas. I know this is a lsn problem, and it seems to be getting better as I put it richer. But it seems very rich, it is about 1 - 2 turns out from flush on the lsn. Also would the hsn be my starting problem?

BTW it's a Picco .26

RE: Having trouble tuning
 

anyone

RE: Having trouble tuning
 

Lsn u say? well take off the whole hsl and the piece the needle is in and you should see the little whole that the fuel goes threw on your low end needle. Line it up right in the middle so that it is right in the center of the circle and then put your high end needle on. Just a thought.