Fastrax Failsafe Query??????
 

Hi guys, I have just tried to install my oldish fastrax failsafe, But I dont have the instructions anymore.
I have connected the throttle linkage wire into the failsafe adapter piece then put the failsafe connecter into/ where the origional throttle connector is. Im sure thats right but I dont know how to set the failsafe up.
Tried holding brake and then pressing the failsafe button hoping it will blink or something but no luck. It seems like thats not the way to do it, does anyone have the instructions which they could tell me thx.


JK

RE: Fastrax Failsafe Query??????
 

i have fastrax fail safes in all my cars they are the tiny ones right? to set mien all u do is connect it turn on the car and controller hold in full brake and use pin to push in the we button for 5 secs r so while the light is flahing then test it out.

RE: Fastrax Failsafe Query??????
 

ill try again later but i briefly tried it earlier and the light didnt flash which was odd but thanks for the low down.

JK