Fixing a ding in the hull
09-30-2010, 12:45 PM
#1
Junior Member
Thread Starter
Join Date: Jul 2006
Location: Eugene,
OR
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Fixing a ding in the hull
We finally got our Nitro Hammer running last weekend. (Long story; between a bad carb from the factory, summer commitments, and such it's been 9 months to get it running.)
Had a few good runs before we had to pack it in. At one point, my daughter ran it into the retrieval boat on idle (she was bringing it to the shore and missed.)
It's got a small ding in the nose - just enough to ruffle the fiberglass and chip the paint; nothing structural.
How does one go about repairing this?
Had a few good runs before we had to pack it in. At one point, my daughter ran it into the retrieval boat on idle (she was bringing it to the shore and missed.)
It's got a small ding in the nose - just enough to ruffle the fiberglass and chip the paint; nothing structural.
How does one go about repairing this?
