Go Back  RCU Forums > RC Boats > RC Boats General Discussion
Reload this Page >

Need help with Miss Budweiser

Notices
RC Boats General Discussion Discuss general rc boating topics here.

Need help with Miss Budweiser

Old 06-25-2004, 10:30 PM
  #1  
sky_dancer
Senior Member
Thread Starter
 
sky_dancer's Avatar
 
Join Date: Jul 2002
Location: Eatonton, GA
Posts: 134
Likes: 0
Received 0 Likes on 0 Posts
Default Need help with Miss Budweiser

Could someone who owns a Horizon Miss Budweiser look at the four screws holding the wing on and tell me which of them has "flexible" washers between the wing and the supports. Is it the front screws or the rear screws or all four? These "flexible washers" appear to be small bits of fuel tubing.
I took the wing loose from my boat to clean off some house paint (don't ask) and I only have to bits of this tubing. I could have dropped the other two. At any rate, if it's only supposed to be two I need to know which two screws it goes on.
Thanks,
Michael
"Planes , Boats, and Trucks
Land, Air, and Sea...I got it covered!!
Old 06-28-2004, 01:31 PM
  #2  
Joel Antonio
Junior Member
 
Joel Antonio's Avatar
 
Join Date: Dec 2002
Location: San Juan, PUERTO RICO (USA)
Posts: 24
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Need help with Miss Budweiser

Hi Michael:

All Four. [:-]
Regards Joel

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell or Share My Personal Information -

Copyright © 2023 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.