Holyeagle

Ron:

I noticed in other postings that you have experience with the Miss Budweiser boat. What tool did you use to adjust the low-speed needle? I don't have anything that will reach under the exhaust and I don't want to take the engine out of the baot to do it.

Thanks
Holyeagle

Ron Olson

My Feedback: (1)

I haven't messed with the low-speed needle and under normal circumstances you shouldn't. These are pre-set by the factory and once they're messed with it's hard to get them back where they were.
You don't have to address this just to me, there are plenty of people on this site that have a lot of knowledge on the Miss Bud's.