RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   RC Car Engines (https://www.rcuniverse.com/forum/rc-car-engines-272/)
-   -   dynamite .19 tmaxx (https://www.rcuniverse.com/forum/rc-car-engines-272/11683522-dynamite-19-tmaxx.html)

meister1993 10-07-2020 04:50 PM

dynamite .19 tmaxx
 
trying to install dynamite .19 in my tmaxx 3.3 followed instructions that came with the enginecant seem to get the clutch bell to spin freely used shims that came with the engine need some help

1QwkSport2.5r 10-08-2020 03:37 AM

The clutchbell doesn’t spin free with the E-clip installed? If you’re using a Traxxas clutchbell, you need to make sure you’re using the Traxxas flywheel nut to install the flywheel. If the nit is too tall, it can interfere with the clutchbell bearing from seating all the way. Most of the time, you need to shim the outside of the clutchbell to move the clutchbell inward to remove some backlash. Too many shims and it will lock up. You need very little backlash - .001-.002” is all you need. Pictures of the setup may help.


All times are GMT -8. The time now is 07:51 AM.


Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.