RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   RC Car General Discussions (https://www.rcuniverse.com/forum/rc-car-general-discussions-179/)
-   -   Nice Tuned pipe for rustler??? (https://www.rcuniverse.com/forum/rc-car-general-discussions-179/1252561-nice-tuned-pipe-rustler.html)

loudpipessavelives 11-04-2003 08:04 PM
Nice Tuned pipe for rustler???
 
I'm looking for a pipe for my rustler, the stock rubber attached to the header and pipe keeps splitting, I have replaced it with copper pipe but it just looks dumb.

I need a pipe that is about the same in length as the factory one because I use a Yank eliminator, chucked to my cordless drill to start it.

The pipe cannot be in the way of the shaft.

I have a MIP stinger on my Nitro PEDE, but I dont want one for the Rusty, any other suggestions?

Mavericman 11-05-2003 04:51 PM
RE: Nice Tuned pipe for rustler???
 
ORIGINAL: loudpipessavelives

I'm looking for a pipe for my rustler, the stock rubber attached to the header and pipe keeps splitting, I have replaced it with copper pipe but it just looks dumb.

I need a pipe that is about the same in length as the factory one because I use a Yank eliminator, chucked to my cordless drill to start it.

The pipe cannot be in the way of the shaft.

I have a MIP stinger on my Nitro PEDE, but I dont want one for the Rusty, any other suggestions?
use the mip touring car side pipe if tou have the .15 it works w/ my pull start

http://www2.towerhobbies.com/cgi-bin...?&I=LXAX70&P=7


All times are GMT -8. The time now is 02:08 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.