Assembly woes
 

I'm new to this forum and real RCs. I'm trying to assemble my first kit, a Kyosho EP UltimaST type R. the problem is I can't seem to get the rear bulkhead on. I don't have my calipers on me so I can't measure the hole spacing to see if it is real tight or what. Any help would be great.

RE: Assembly woes
 

Never mind about the bulkhead I got that by flexing the body a little. the slipper clutch is a real pain in the ***** though. I'm not complaing, but; can't these companies put , well... Directions in ther assembly manual. I don't read japaneese at all.

RE: Assembly woes
 

Some companys figure by the time you buy a good RC you have allready put a few kits together so instructions are not always up to par. The good news is your next one will be easy now that you have done it.
Congrats on your new car welcome to RC. Happy Running:D

RE: Assembly woes
 

Well it's not there yet, thanks anyway. I've still got to put the front together. then it's time to wire it up and see what it can do.
I'm just sick of my rookie mistakes. ( I had problems with the slipper clutch/dif because I was using the wrong size Allen Doh'.

RE: Assembly woes
 

We all learn by our mistakes and we all have one thing in common we were all rookies once.
The areas you had problems is the hardest part to assemble so its down hill from there.
Let us no when you get it going.
Happy RCing

RE: Assembly woes
 

It is not done yet.( my wife said I can't call in sick just to play with the stadium truck). Go figure

RE: Assembly woes
 

It is not done yet.( my wife said I can't call in sick just to play with the stadium truck). Go figure