RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   RC Car General Discussions (https://www.rcuniverse.com/forum/rc-car-general-discussions-179/)
-   -   ansmann virus problem (https://www.rcuniverse.com/forum/rc-car-general-discussions-179/6810133-ansmann-virus-problem.html)

spoonrc 12-27-2007 05:49 AM

ansmann virus problem
 
Hey,

I just bought an ansmann virus nitro car and ran it in with 5 tanks of 5% run in fuel. And then after those 5 tanks i ran it on 16% nitro fuel at half throttle for another tank and then after that tank i started to race with my friends cen nemesis. it went well until it flipped and then since then i haven't been able to run it properly. When i start it the throttle has to be on full for it to start and then when it starts it revs a lot. When i give it some throttle it revs even more but barely moves, and then when i pull the trigger more than half way it stalls itself. Also sometimes when I am idling it, it stalls itself for no reason.


If anyone could please help me with this it would be great.


Thanks...

crowdie 12-27-2007 06:21 AM

RE: ansmann virus problem
 
5% run in? I havent heard of that. I think that could of possibly damaged your engine but im not sure. If its not that my friend had the same "symptons" on his touring car. It turned out his clutch had gone or "broke". After he replaced that it worked so you never know, have a look at it. Also, have you got a hot plug in your virus? i was going to get one and the hobby shop man (XD) told me it would need one so yeah that could help.

skinnyboy 03-09-2008 04:11 PM

RE: ansmann virus problem
 
i bought the ARN-1 RTR i started it and it went crazy and shaterd the cluth bell got a new one from them straight away, but not sure if carb settings are right can anyone give me advice?


All times are GMT -8. The time now is 02:58 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.