Dynamite Tazer 12T Blinking?
 

hey all,

i just finished assembling my RC18T Factory Team and went to program the ESC (Dynamite Tazer 12T). This ESC was in a buggy of mine before and worked just fine. I put it in attached a charged battery and plugged it into the receiver to program it, but all i get is a blinking red light and then nothing there after. The light blinks for a couple seconds pretty quickly and then there is no response after that. I hit the program button, but again, still nothing. If anyone has any ideas as to what is wrong, I would really appreciate it!

thanks,
adam

RE: Dynamite Tazer 12T Blinking?
 

okay, so i have gotten the ESC to work, but i am still thoroughly confused haha

the plan was to use my radio in both my TT-01R and RC18T FT. i figured all i would have to do was pull the receiver from one and put it in the other. when i do this is when i get the blinking and no result (Dynamite) in the RC18 and then when i put it back in the TT-01 i have to reprogram the ESC (Novak) in that.

so to test the Dynamite in the RC18 i went and got an old AM radio that i'm not using anymore and it works totally fine. is there something special i have to do to share a receiver between two cars?

thanks,
adam

RE: Dynamite Tazer 12T Blinking?
 

alrighty, well i seemed to have fixed the problem.

the plug on the Dynamite ESC needed to be trimmed a bit on the side to fit all the way down in the R153F receiver. it just wasnt seating all the way. trimmed it a bit and everything seems to be working as it should!