Hi i was wondering how thin does the ABS pipe need to be on the wheel by thin im talking about width , and also how can i get an even cut on the abs please help

I just cut the ABS 1 inch but the problem now is that the body wont fit what should i do what should i do[&o]

cssdev can help you. He makes them too. PM him.

I just cut mine to the same width the the wheel, the file the edges just a little bit to round them (yeah, it makes it look more like a tire, but I really do it because it keeps the ABS from snagging on things when its sliding)

You can get a straight cut by hand, if you are careful, or you can use a bandsaw to make perfect cuts.

what do you mean the body won't fit? Won't fit how?

i use abs pipes to if ur body doesnt fit maybe u cut them to wide or just try lifting the bodie up on the posts and try that and see if that works but i dont understand y the body wont fit and by the way dev doesnt have the internet anymore he is movin but he thinks he will get it back cuz he isnt movin in a bit so he might be back on idk but anyways try movin up the bodie on the bodie posts and see if that helps

well the abs is as close as i can get it to the width of the rim, do you think it will be ok if i made the abs skinnier it would still slide around

yeah it should be ok just put tape on the rim and slide the pipe over it for a snug fit yeah it should be fine