Duratrax Evader Bushless servo question
#26
Senior Member
Join Date: Feb 2005
Location: Fresno,
CA
Posts: 1,026
Likes: 0
Received 0 Likes
on
0 Posts
RE: Duratrax Evader Bushless servo question
Not to thread jack, but I just purchased a brushless evader as well. Moving my hop-ups from my old nitro evader to it.
Will be racing the evader at my local track along with a DXR8-E. Also race a 3racing Sakra S Zero and Tamiya TB-03 at the on road track.
Fun times ahead!
Will be racing the evader at my local track along with a DXR8-E. Also race a 3racing Sakra S Zero and Tamiya TB-03 at the on road track.
Fun times ahead!
#27
Junior Member
Thread Starter
Join Date: Dec 2012
Location: Bronte, TX
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
RE: Duratrax Evader Bushless servo question
Well the poor servo did give out this afternoon but when I checked the mail the new one was there...lol. Pretty painless swap but I was just worried about stripping out screws in the all plastic chassis. However I just took my time and when they felt snug STOP!!
Took it out for a quick run and works like a champ
Took it out for a quick run and works like a champ