Yokomo S-PRO 8T 3W
09-29-2003, 10:24 AM
#1
Junior Member
Thread Starter
Join Date: Mar 2003
Location: Vienna, AUSTRIA
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Yokomo S-PRO 8T 3W
Hi,
I have done some break in with this motor with a single cell and without any motor load(around 10minuts)
After my First real run (just 5 minuts), with a 5:1 gear and my 3300NiMh with a no Limit ESC, I have detected that the comm is not as new:
The part of the comm near the gap (only in one direction) it is not more shining (it look pretty dark and scretched), the rest of the Comm it is still gold shining.
The brushes are till looking normal.
The motor was very hot, even after a short run!
Is this normal ?
Danke
e_lm_70
So far I have never seen this wear with a more used 11T 2W (Pro Stock II).
I have done some break in with this motor with a single cell and without any motor load(around 10minuts)
After my First real run (just 5 minuts), with a 5:1 gear and my 3300NiMh with a no Limit ESC, I have detected that the comm is not as new:
The part of the comm near the gap (only in one direction) it is not more shining (it look pretty dark and scretched), the rest of the Comm it is still gold shining.
The brushes are till looking normal.
The motor was very hot, even after a short run!
Is this normal ?
Danke
e_lm_70
So far I have never seen this wear with a more used 11T 2W (Pro Stock II).
