Revo Brushless conversion
#1
Senior Member
Thread Starter
Join Date: Apr 2005
Location: Blakeslee,
PA
Posts: 607
Likes: 0
Received 0 Likes
on
0 Posts
Revo Brushless conversion
Hey guys, im thinkin about converting my revo 2.5r to brushless-my question is-should i buy a conversion kit like tekno and sell off the nitro stuff(o.s 18tm-healthy-plus all the nitro specific stuff) or buy a e-revo chassis and swap over anything ill need(idc if its plastic)-if i buy a e-revo chassis(well it looks like the front/rear ends will fit)-what about center driveshafts lenghts-is the e-revo chassis the same length as 2.5/3.3??-as for esc/motor'sim still on the fence(vxl-3s cause its waterproof/2000kv-2500kv motor)-i only have 2s/3s lipos. thanks guys
#2
Senior Member
RE: Revo Brushless conversion
I think Revo and E-Revo are completely different truck. Not many parts are compatible. So, there is no point of buying an E-Revo chassis.
The better route is to either get a conversion kit or do it yourself kit.
The better route is to either get a conversion kit or do it yourself kit.
#3
Senior Member
Thread Starter
Join Date: Apr 2005
Location: Blakeslee,
PA
Posts: 607
Likes: 0
Received 0 Likes
on
0 Posts
RE: Revo Brushless conversion
Yeah i think ill just keep it nitro as i have a slash 4x4 and bl 2wd slash so when i want the nitro noise and smell ill just fire it up-lol