MBX R2 Nitro to Brushless Conversion Issue
Hello All! My old OFNA MBX truggy XTM 24.7 motor is cooked.
I located a mount and purchased a brushless ESC / Motor I'm using an old KO Propo radio and Nova receiver. When I turn it on the steering works and the motor seems to rev fine for a few seconds then goes to a single speed until I cycle the system and then it does the same thing again. Could it be that my radio/receiver are just not compatible with the brushless system? https://cimg1.ibsrv.net/gimg/www.rcu...d42ea2743f.jpg https://cimg3.ibsrv.net/gimg/www.rcu...464501a8aa.jpg https://cimg4.ibsrv.net/gimg/www.rcu...80545cce5d.jpg |
All times are GMT -8. The time now is 09:16 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.