Editing par files in FMS
12-13-2001, 09:31 AM
#1
Thread Starter
My Feedback: (3)
Join Date: Dec 2001
Location: Meridian, ID
Posts: 674
Likes: 0
Received 0 Likes
on
0 Posts
Editing par files in FMS
I've been having moderate success editing the flight parameters in FMS thanks to this page http://home.introweb.nl/~erics/fms/par.htm
My question is how to edit some of the more advanced characteristics such as dihedral, tail-momentss etc. I may be pushing the capabilities of the program, but I've downloaded several models that just fly right. I think a better translation as to what parameters do what would help a lot. However, I sure appreciate the work put into this translation. I guess what I'm after is the ability to perform 3D stuff and still have gravity. Is anyone further along with this than I am?
My question is how to edit some of the more advanced characteristics such as dihedral, tail-momentss etc. I may be pushing the capabilities of the program, but I've downloaded several models that just fly right. I think a better translation as to what parameters do what would help a lot. However, I sure appreciate the work put into this translation. I guess what I'm after is the ability to perform 3D stuff and still have gravity. Is anyone further along with this than I am?
12-27-2001, 07:42 PM
#2
Senior Member
My Feedback: (1)
Join Date: Dec 2001
Location: Ridgecrest,
CA
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
Editing par files in FMS
If you go to the home page of FMS there is a download page. At the bottom of that page there is a program to design your own heli or plane. Works well although its all in German!
Dr.Tim
Dr.Tim
