RF 6 trim ?
 

I've found that very few planes need trimmed for what I do with them on RF6 , but I wondered what you do with the trim buttons on yours?

Do you guys trim every plane that needs it then re-trim later when switching planes or perhaps does it remember each trim setting for each model?

I do use a real TX for multiple planes when I fly RC , but it makes trimming a real pain unless I write it down. And then one has to remember which model is last flown and remember to re-trim for the next model. Is this going to be the method most users do when using the single interlink TX for multiple models on RF6?

Thanks.