Game Commander and AFP
 

Hi,

I just purchased Aerofly Pro, and I think the graphics are great. However, I am using a game commander and the controls are very "jumpy". It's very difficult to control the planes. I've tried calibrating the system several times without much improvement. Has anyone else had this experience? BTW - I have installe the 1.6.8 (appeared to help a little).

Any advice on setting up the controls is appreciated.

Thanks,
Trent

RE: Game Commander and AFP
 

Use your own Tx, especially if you have a computer radio. You'll love it

RE: Game Commander and AFP
 

Put Expotential in. 30% to start. Also almost every plane is overpowered. Reduce you horsepower by 25% .... now try again!

This will help.

RE: Game Commander and AFP
 

Did you calibrate the GC under Windows??

Then you calibarte under AFP.

The GC is actually quite smooth. (IMHO)

RE: Game Commander and AFP
 

Got it to work today. I re-calibrated under both Windows/AFP again. Suspect that I may have move the sticks too quickly the first couple of times. Flying smoothly now (well, at least the controls are smooth). Thanks to everyone for the advice.

RE: Game Commander and AFP
 

Hi, I have a question. If you use your own Tx does the Tx's battery need to be charged, or does the power come from the computer to the Tx?

Thanks,
Matt

RE: Game Commander and AFP
 

Matt, you'll need power from your Tx. However, you'll get to use all the program mixing and dual rate functions in your Tx, assuming it's computerised.

RE: Game Commander and AFP
 

You still need about 30% expo on each stick though, especially if you are going to 3D it.

RE: Game Commander and AFP
 

You can set different expo for lo and ho rates through the radio e.g. 30% expo on lo-rate, 60% expo on hi-rate, for any control surface

RE: Game Commander and AFP
 

Ok, I do have a futaba 6xas thats computerized so I would have to charge it.

Thanks for the info.

Matt