AFP radio setup problem
I just installed AFP version 1.2.6 I am having a hard time setting up the futaba 9cap radio. First off, the red lines during calibration keep jumping if i touch the metal part of the radio with my fingers...very odd. If i just move the sticks without holding the radio in my hand the lines stop, but dont respond stick movements. Is there a problem with the radio???? I have been using this radio to fly jets with no problem. The connection made to the PC is on a com port using the cable supplied with the software. Also, there is no radio installed in the control panel game controller section. Is something supposed to be there as well. I use this same radio with G2 and it works perfectly. I am using the g2 cable to connect the 9cap with the AFP serial cable.
|
RE: AFP radio setup problem
Make sure you install the patch. But do so after you install Disc 1 and the Expansion pack. The patch can be found [link=http://www.aeroflypro.com]here[/link]. Just look on the right side of the page.
Also try removing your Xtal or module. See if that helps! |
RE: AFP radio setup problem
OK, tried this and there is slight improvement. THe red bars still shake if I dont "ground the radio with my fingers" so to speak. But atleast the plane flies now. THe simulation speed is slow, although general options box says its 100%. The moment i remove my fingers from the metal portion plane goes crazy as all controls go awry. This is strange. Is it the cable or the radio or my com port?
|
RE: AFP radio setup problem
forgot to mention that the module has been OUT from the beginning and the radio is fully charged.
|
RE: AFP radio setup problem
When you say it's slow is that the frames per second or simulation speed? The sim runs best at 120% simulation speed under options.
Look bottom right and get FPS info and post. |
RE: AFP radio setup problem
Ragz, I have the same problem with my 9c and AFP. If I'm not touching the tx, the plane goes haywire. I think you are correct. It is not grounding properly. Odd.
|
RE: AFP radio setup problem
hehe..this is crazy...what can be the solution?
|
RE: AFP radio setup problem
Connect a lightening rod to your antennae[:@]
|
RE: AFP radio setup problem
seems like there are quite a few people that are facing this problem...??????
|
RE: AFP radio setup problem
So whats the solution to this problem guys? Dont tell me we have to ground the radio each time we fly this sim? I would hate to tinker with the radio or the cable, but to make this thing work, I will give it a go. Please let me know what is to be done.
|
RE: AFP radio setup problem
I can no longer calibrate my controls. Channel 1 (AIL) does not go all the way across the test area on the mid range set & is also lopsided on the extreme range set.
There is also a problem with the channel 3 & 4, but, not as much as channel 1. Initially I thought I had lost my right Aileron control because I had a timer set, but, I turned that off completely & the problem remained. I also switch to a different radio & the problem is the same. I checked the cabling by disconnecting one segment at a time & with the entire cable disconnected the end results are the same, the model spins off to the right & flips over backwards. I rebooted my computer several times & decided I would reinstall the program tomorrow, I've had enough for today. If anyone has experienced this problem... I'm all ears. Thanks in advance. |
All times are GMT -8. The time now is 09:29 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.