marder won't start
 

hi i ran my marder yesterday to try out the wireless camera. it started beautiful yesterday and all the other times i started it. today it will not start not even a pop. i have gas, i have spark. when i take the plug out and pull the recoil you can see the gas comming out of the spark plug hole. i have not touched the needle adjustments. thanks shymot

RE: marder won't start
 

might just be flooded. try some starter fluid. also the carb needles could be dirty. i'd spray some carb and choke cleaner in it. also i've had my hi and low jets turn themselfs from vibration.

RE: marder won't start
 

If you had it running before and you checked the pug ,you can still have a bad plug. I had the same problem but discovered a bad plug. It would start the day before and the next day start hard.

RE: marder won't start
 

Proble the Plug m8 :)

but if it's flooded then a couple of pulls on the rip start with the plug out and full throtall then plug back in and it should fire up :)


hope this helps Arky

RE: marder won't start
 

i would just try putting a new plug in, or if that doesnt work adjust the carb settings to the FG standard settings

RE: marder won't start
 

hi neb, yes it was the plug.started right up.unfortunately now i have side swiped a planter box and broke the upper right rear suspension arm.

RE: marder won't start
 

hi arky it was the plug, thank you for your imput

RE: marder won't start
 

thanks mbbaj2001 it was the plug

RE: marder won't start
 

hi pb_paulie_b thanks for your input.turns out it was the plug
thank you

RE: marder won't start
 

try mixing your oil at 50:1 use a good synthetic, will keep that plugfrom fouling.